![]() ![]() 30274 part has proven more reliable than the 336 gen 3 ejector. It's not a lot of money and they should not HURT the pistol's performance. Glock OEM Trigger Housing Fits Gen 3 w Polished Ejector 30274 Ejection fix. Replacement Glock Trigger Housing Ejector 30274 fits 9mm 17 19 26 34 Brand New 12. If there is anything in the process that is not quite right then you are left with extractors like mine - they were "chewed the Hell up" at the 500 round mark.īefore the APEX kit was available I tried to increase extractor tension and there was a noticeable improvement but the pistol(s) were probably 1 failure to feed in 60 rounds and the ejection was all over the place with one coming in hot and fast right into my face once every 60 rounds. The extractor design does not lend itself to MIM as does a design with less geometry changes, tight radii, etc. Now I cannot vouch that this will work on 100% of Gen4 and Gen3 pistols but it has stopped the erratic ejection on five (5) of five (5) thus far.īeing an mechanical engineer I observed the following: I plan to buy a new gen3 trigger block and a gen4 trigger block( to take the ejector out). I always replace the 336 ejector in the housing with a 30274 ejector but. I went on the Glock Store, looked like the gen4 ejector(30274) can just fit into the gen3 trigger block. Factory Glock Trigger Mechanism Housing w/ 336 ejector (9mm Gen 3) 13. I also replace the standard spring loaded bearing for the non-LCI spring Loaded Bearing (it's a little longer which gives more preload on the extractor). 2) I want to change the ejector to gen4 as I read and watch on line that gen 4 is better. Supposedly, Glock later changed to the 30274 'Trigger housing with Ejector' assembly in the Generation 4 guns, and that remedied the brass to face issues. Then install the APEX Failure Resistant Extractor. (2) insure you have the latest recoil spring assembly - or the equivalent if you wish to run a SS guide rod. One thing that I have found to work on a total of five (5) pistols is the following: ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |